Omnitronic Combo-160BT, User Manual

Page: 19 / 24

19
1 USB port
To connect the optional USB dongle UWM-2HH for wireless microphone operation. The LEDs
below light when the wireless signals are received.
2 Volume control
To mix the signal of the wireless microphones 1 and 2 to the master signal.
3
Tone controls TREBLE/BASS
2-band EQ for tuning the tone of the mono inputs CH 1 and 2.
4
Intensity control REVERB
Adjusts the intensity of the internal reverb effect of the mono inputs CH 1 and 2.
5 Volume control
To mix the signal of the mono inputs CH 1 and 2 to the master signal.
6
Mono input CH 1/CH 2 with level switch
Balanced combo input (XLR/6.3 mm jack) for the mono inputs CH 1 and 2. Adjust the input level
with the LINE/MIC selector switch: LINE = for audio units with line output (e.g. CD player or
instrument), MIC = for microphones.
7 Bluetooth button PAIR
To activate the Bluetooth module press and hold the PAIR button for 2 seconds after switching
on. Shortly press the PAIR button again to enter the pairing mode. The LED lights solid while
pairing and flashes when paired.
8 Volume control
To mix the signal of stereo input CH 3/4 to the master signal.
9
Stereo input CH 3/4
Unbalanced 6.3 mm and RCA jacks for channel 3/4 for connecting audio units with line output.
10 Volume control
Common level control for the Bluetooth receiver and the AUX input.
11
AUX input CH 5/6
3.5 mm jack for connecting portable audio devices without Bluetooth (e.g. MP3 players).
12 Volume control for the monitor output
13 MONITOR OUT jacks
Unbalanced 6.3 mm jacks for connecting an amplifier of a monitor system.
14 MASTER VOLUME control for the overall signal
15 LIMITER indicator
Lights up when the signal level is too high; the limiter will reduce the signal level to protect the
speakers.
16 POWER indicator
17 Speaker connectors
6.3 mm jacks for connecting the left and right speaker.
18 Power input
Plug in the supplied power cable here.
19 Fuse
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same
rating and power. The correct fuse value is specified on the rear panel.
20 Voltage selector switch
21 Power switch