41
44
Ground Terminal
Ground clamping screw for turntables with separate ground lead.
45
CD Inputs
RCA inputs L/R for connecting analog units with line level outputs (e.g. CD players) or turntables
with magnetic system.
46
Input Selectors LN/PH
Switch the analog inputs LN/PH [43] between phono input and line input.
Note: Switch off the unit before changing the position of a switch.
..............................................................................................................................................................................
5
HARDWARE SETTINGS
It is possible to change the light mode of certain LEDs by means of button combinations to adjust to DJ
software without MIDI out command such as Serato Scratch Live. In the basic setting, all LEDs light
according to the commands of the DJ software. If you enable the user-defined mode, you can select
between HOLD and TOGGLE mode for each LED individually. In HOLD mode the LED lights until you press
the button once again, in TOGGLE mode the LED lights with each actuation of the button. You can adjust
any LED except for CH1 CUE, CH2 CUE, FADER START, CH1/2 XF REVERSE, TALKOVER, MIXER MIDI,
SHIFT, SAMPLES and HOT CUE.
1
To activate the setting mode, hold both FADERSTART buttons and switch on the unit simultaneously.
2
The left CUE 1 button lights to indicate the basic setting is enabled (all LEDs light according to the
commands of the DJ software).
3
Press the right CUE 2 button to switch to user-defined mode. Now each LED is in HOLD mode. To
switch an LED to TOGGLE mode, press the respective button so that it lights.
4
To save your settings, keep both FADER START buttons pressed until they flash repeatedly. Then
shortly switch off the mixer and switch it on again.
Summary of Contents for CMX-2000
Page 1: ......
Page 63: ...63 NOTES...
