36
The OmniBeacon™ is now ready to be powered on.
Once powered on, it will attempt to connect to the
cellular network.
(1)
As soon as OmniBeacon™ is connected to power, it will turn
on and attempt to connect with the cellular network.
(2)
While OmniBeacon™ is attempting to connect the status
light will blink
green
and will also beep.
(3)
Wait for the status light to turn solid
green
; this can take up
to 1 minute.
Connecting to Cellular Network
The status light may briefly turn
red
. If the status light stays
red
for more than 1 minute, refer to the troubleshooting
section of this manual.
NOTE:
The status light is the tiny LED light on the main circuit board. It is
NOT
the large alarm light cluster. The tiny status LED is located under the
OmniBeacon™ orange protective lens, and can be faintly seen through the
lens. Don’t worry, this small LED is only used during startup to troubleshoot weak
cellular signals, and is not used after startup is complete.
Summary of Contents for OmniBeacon GuardDog
