19
(1)
Using the base foam gasket as a drilling template, mark
hole locations in 5 places. Drill or punch four 3/16” holes
and one 3/4” hole.
(2)
Place the gasket on a mounting surface and line up four 3/16”
holes for the #8 machine screws.
(3)
Remove the ¾” conduit nut from the chase nipple.
It will be secured in step (7).
(4)
Pass the OmniBeacon wires and chase nipple through the
¾” hole. Line up four 3/16” holes with the mounting feet.
(5)
Locate the four 8-32 Stainless Steel machine screws and
four #8 Neoprene Sealing Washers.
(6)
Insert the 8-32 Stainless Steel machine screws into the #8
Neoprene Sealing Washers, and then insert this into the
four base feet. Attach the four 8-32 Stainless Steel nuts
from the underside. Tighten the nuts snuggly.
(7)
Feed wires through the ¾” conduit nut and tighten
to chase nipple.
(8)
Refer to Electrical Connections section for wiring details.
Summary of Contents for OmniBeacon GuardDog
