Configuring the UM-1 adaptor plate
Measure display
The UM-1 ships with a standard set of mounting rails pre-installed.
These rails will fit a display where the vertical distance between
mounting lands on the display are 17 1/8” or less. If your display is
larger than this, you will need to install the large set of mounting rails,
which are included with the UM-1. Please see
Install Mounting Rails
at
the end of this section for details.
Set UM-1 width
The UM-1 is capable of handling a wide range of landed insert widths.
Measure the horizontal distance between mounting lands on your
display, and set the width of the Mounting Rails as shown,
Standard Range:
38 ½” (98 cm) to 15 ¾” (40 cm)
Standard Configuration
For standard range configurations, loosen the screws on the sliders using
the supplied Allen wrench, adjust rails to desired width, and then re-
tighten screws.
Narrow Range:
15 ½” (39 cm) to 3 ½” (9 cm)
Narrow Configuration
For narrow range configurations, flip slider/rail assembly over (as shown
below) before inserting them into the channels.
Secure sliders and back plate
Secure sliders with (8) button head screws.
For
medium and narrow displays, where the nuts on the slider are
beneath the back plate, thread button head screws through the back
plate and into the slider as shown.
Note:
The ou er co ne s of the back pla e must always be secured with a
screw.
t
r r
t
For
wide displays, where the nuts on the slider are positioned outside of
the back plate, use lock nut with button head screws (supplied) to
secure the back plate, as shown at right.
3
