6.
Drill mounting holes with 9/32” bit. Mounting holes should be 3”
(76 mm) deep.
Mounting to Masonry
1.
Using the wall plate as a template, mark the mounting holes in the
desired mounting location.
2.
Drill mounting holes with 3/8” (10mm) masonry bit. Mounting holes
should be a minimum of 2 9/16” (65mm) deep.
3.
Insert masonry mounting anchors (not supplied) into holes, and tap
flush with hammer.
Proceed to
Mounting Cantilever Assembly
Mounting Cantilever Assembly
1.
Important:
for the display to be centered over the wall plate when
the cantilever arm is folded, the arm will need to be offset by
approximately 4” (10.1 cm) from the desired center position of the
screen. To do this, first note where the desired center of screen position
intersects the wall plate, and then mark the wall plate.
2.
Attach cantilever arm to the wall plate at the indicated offset
location.
3.
Mount cantilever assembly to wall using supplied 3/8” lag bolts.
4.
Fold cantilever arm to verify center location of mounting head.
Note:
the mounting head will be centered with the arm folded in one
direction only.
Center of screen
2 mounting hole offset
Cantilever arm assembly
2
