M1260F Revised 12.05.06 Ver. 2
Data subject to change without notice
©
Copyright OMNIFLEX
IGM1260FR02 Part Number 8.0101.036
Pin
number
Communication Standard
RS232
RS485
1
Do not connect
Rx Data + (In)
2
Rx Data (In)
Rx Data
– (In)
3
Tx Data (Out)
Do not connect
4
Do not connect
Tx Data+ (Out)
5
Ground
Ground
6
Do not connect
Vcc
7
RTS (Out)
Do not connect
8
CTS (In)
Do not connect
9
Do not connect
Tx Data
– (Out)
Serial Port Default Settings
1. The default Protocol is Conet/s.
2. The default Baud Rate is 19200.
3. The default Data Bits is 8.
4. The default Parity is None.
5. The default Stop bits is 1 Stop Bit.
6. The default DTR/CTS Handshaking is Off.
7. The default DTR/CTS Timeout (ms) is 0.
Changing Serial Port Settings
1. Assemble the Maxiflex base as shown in Figure 1 with the M1260 fitted into the CPU slot
and a suitable Maxiflex PSU in the PSU slot
2. Connect power to your system.
3. Connect the M1831 programming cable between the COM port of your PC/laptop and the
programming port of the Maxiflex CPU.
4. Open Omniset and click on File->Connect->Maxiflex CPU TAB.
Select the GROUP Configuration->Ports->Serial Port which is found in the left hand pane.
Change your Serial Port settings by pointing the mouse to the ITEM you wish to change and
clicking on the right mouse button and selecting the New Value option that pops up. Enter you
new setting when prompted. Refer to screen grab below.
