Omnicomm LLS 5, User Manual

Page: 13 / 26

“Data output interval” (1 to 255 seconds) – set the automatic data output interval
The automatic data output mode may be used with no more than one Omnicomm LLS 5
sensor connected to one interface.
“Heavy exploitation conditions” - turn on for additional filtering of measurement
values that takes into account severe operating conditions.
“Parameters initialization” - displays the correctness of calibration results. Options:
“Yes” - the calibration results are correct
“No” - a recalibration of the sensor is required
Installation and Connection
When installing the fuel level sensor onto the plastic fuel tank it is important to provide a
secure electrical connection between the sensor's body and the frame of the vehicle. If
this condition isn't met, it can lead to sensor malfunction caused by static electricity.
For installation onto cylindrical fuel tanks with the diameter 420...710 mm follow the
instructions in the section
Fuel level sensor installation recommendations for cylindrical
fuel tanks .
1. Put the mounting point gasket (included in the kit) on the measuring probe of the
Omnicomm LLS sensor
2. Put the Omnicomm LLS sensor into the tank and secure it:
when securing with rivets, use a riveter
when securing with bolts, first put a seal (one on each bolt), a spacer and a spring
washer
when securing onto a plastic tank with wall thickness of more than 3 mm, use the self-
tapping screws and a seal (one on each self-tapping screw), included in the kit
3. Connect the Omnicomm LLS sensors to an external device as shown in the diagram:
13
Installation and Connection