10. We strongly suggest listening to all the factory presets, regardless of their
name, to get a feel for their differences and then select one to start with.
Note that when running GForce, presets from earlier non-GForce versions
cannot be used and you’ll need to start fresh. (Trust us, it’s worth it!) Note
however that you can revert to the earlier “orange” mode from the remote
control web interface if necessary. Once you have your starting preset
selected, touch the
“Quick Setup”
tab and adjust the following controls to
set the basic loudness, bass and brightness sound desired.
Adjust the
“Clipper Drive”
control as low as possible for the loudness need-
ed. This controls the primary loudness vs. distortion tradeoff. Turning it up
makes the sound louder (but more distorted) while turning it down makes
the sound cleaner but not as loud. The goal is to find the right compromise.
Try adjusting it down in 0.5 dB steps until the loudness just falls off a little
too much, then bring it back up a notch or two from there. It should always
be set as low as possible for the needed level of loudness.
The overall amount of bass is set using the
“Bass”
control. At higher settings
of the
“Bass Thump”
control, the “kick” or “Thump” action of bass material
is emphasized.
The basic brightness of a preset is set by using the
“Presence”, “Treble”
and
“Sparkle”
controls. Note that these three controls only boost the brightness.
A setting of “0.0” is “flat” or the minimum amount of boost for the particular
preset that is currently selected. Reducing brightness can be done, for one
example, by reducing the higher bands of the AGC or Limiter mixers.
6
|
OMNIA.11 - QUICK-START SETUP GUIDE
Summary of Contents for Omnia.11 2001-00382-000
Page 11: ......