9
SECTION 3. SONIC RUPTOR 400 SET-UP
Locate the BNC transducer outlet on the rear panel of the control unit. Insert the transducer
assembly’s BNC connector into this BNC outlet. The Omni Sonic Ruptor 400 will not operate
unless the plug is in place.
Connect the power cord to the power entry module located on the rear panel of the control
unit. Plug the power cord into a grounded outlet of 115 volts, 60 cycles, or 230 volts, 50
cycles, AC. Check the Serial Plate and power entry module on the rear panel for voltage
requirements.
Using the pair of 1.5” diameter Pin Wrenches, tighten the Tip to the Transducer assembly.
CAUTION:
Use the wrenches to twist the Tip, not the Transducer!
Use the wrenches to check the tightness of the probe periodically after processing.
