Omni 3760-912, Instruction Manual, Page: 7 / 25

Electrical Connection
Improper use of the grounded plug can result in the risk
of electrical shock. If the power cord is damaged, have it
replaced by an authorized service center
.
5
This refrigerator should be properly grounded for your safety. The power cord of this
refrigerator is equipped with a three prong plug which mates with standard three prong
wall outlets to minimize the possibility of electrical shock.
Do not, under any circumstances, cut or remove the third ground prong from the power
cord supplied.
This refrigerator requires a standard 115/120 Volt A.C. ~/60Hz electrical outlet with
three prong ground.
This refrigerator is not designed to be used with an inverter.
The cord should be secured behind the refrigerator and not left exposed or dangling to
prevent accidental injury.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and
pull straight out from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a
qualified electrician or service technician install an outlet near the appliance. Use of an
extension cord can negatively affect the performance of the unit.
Operating Your Refrigerator
Temperature Control
The temperature control is located inside the refrigerator and in the freezer
compartment on some models. The temperature is factory preset to provide satisfactory
food storage temperatures. However, the temperature control is adjustable to provide a
range of temperatures for your personal satisfaction.
To adjust the temperature colder in the refrigerator compartment, press the SET button
on the control panel so that the display light shifts to a higher number. “1” is the warmest
setting and “5” is the coldest. To adjust the temperature colder in the freezer compartment,
move the Freezer Control knob towards the maximum setting. After each movement of
either control, allow 24 hours for the unit to adjust. If the unit is still not cold enough, repeat
until desired temperature is achieved.
To adjust the temperature warmer in the refrigerator compartment, press the SET button on
the control panel so that the display light shifts to a lower number. To adjust the temperature
warmer in the freezer compartment, move the Freezer Control knob towards the minimum
setting. After each movement of either control, allow 24 hours for the unit to adjust. If the
unit is still not warm enough, repeat until desired temperature is achieved.