Omni 3760-912, Instruction Manual, Page: 6 / 25

Installation Instructions
Before Using Your Refrigerator
Remove the exterior and interior packing.
Before connecting the refrigerator to the power source, let it stand upright for
approximately 4 hours. This will reduce the possibility of a malfunction in the cooling
system from improper handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Location
Do not recess or build-in. This appliance is designed to be free standing only.
Allow 5 inches clearance space between the back and sides of the refrigerator,
which allows the proper air ventilation.
Avoid Installation
:
o On weak surfaces unable to support refrigerator when fully loaded.
o In direct sunlight and sources of heat (stove, heater, radiator, etc.). Ambient
temperature below 50°F or above 85°F will hinder the performance of this
appliance.
o In moist areas.
o In garage. This unit is not designed for any type of outside installation.
o In moving vehicle. This unit is not designed to be installed in an RV or
used with an inverter. This unit is is intended for household use only.
Installing Your Refrigerator
Adjust the leveling feet to keep the refrigerator level.
Plug the refrigerator into dedicated, properly installed grounded wall outlet. Do not
under any circumstances cut or remove the third prong from the power cord.
After plugging the appliance into a wall outlet, turn the unit on and allow the unit to
cool down for 24 hours before placing food in the refrigerator or freezer compartment.
4