9
8
omnicubed.com
Pro-Anchor™ Electric
INSTRUCTIONS
Assembly
Remove rubber insulation cover.
(see fig. 1)
Orient the grinder so that the power
switch faces the side, NOT top or bottom.
Align grinder spindle clamp so that the
square edge faces up. (see fig. 2)
The clamp has an oblong shape to properly
fit the spindle body. Improper alignment of
clamp or grinder will damage the spindle
bearings.
Push spindle clamp onto grinder spindle
body until it is flush with the end.
Tighten the clamp with a 3/16″ hex key.
(see fig. 3)
Center the grinder with spindle clamp
attached between the pivot screws on the
machine. Evenly tighten both the left and
right pivot screws with a 3/16″ hex key.
(see fig. 4)
Check the grinder’s up and down
movement; grinder should be firmly in
place yet move smoothly and easily.
(see fig. 5)
Adjust pivot screws as needed.
Using a 9/16″ wrench, tighten jam nut
on both pivot screws to lock pivot screw
position. (see fig. 6)
Usage Tips
For both electric models:
Install T-31 anchor bits with 1/4” shank
according to the grinder manufacturer’s
instructions. (Anchor bits not included.)
Attach water hose to provide water as
coolant during cutting.
Use water control valve to adjust coolant
flow.
Aim water nozzle toward cut.
(see fig. 7)
Usage tips continued on the next page.
.1
.3
.4
.2
.6
.5
.7
Summary of Contents for PA-132-E
Page 1: ...PRO ANCHOR ELECTRIC...
