Omicron C-Probe 1, User Manual

Page: 7 / 34

7
Safety Instructions
2 Safety Instructions
Before using C-Probe 1, please read the following safety instructions
carefully.
Without a detailed knowledge about the safety instructions, C-Probe 1 may
not be set into operation!
C-Probe 1 may only be operated by authorized personnel.
2.1 Principle Rules for Usage
• C-Probe 1 should only be used when in a technically sound condition. Its
use should be in accordance with the regulations, in a safe manner, and
mindful of the dangers. In particular, avoid disruptions that could in turn
affect safety.
• C-Probe 1 is exclusively intended for the measurement of DC and AC
currents within the ranges specified in this operation manual (refer to 3.3
“Input and Output Quantities” on page 10). Any other use is deemed as
not being according to the regulations. The manufacturer/distributor are
not liable for damage resulting from unintended usage. The user alone
assumes all responsibility and risk.
• Adhering to the instructions provided in this operations manual is also
considered part of being accordance with the regulations.
2.2 Safety Operation
• Never use the current clamp at substations which carry a potential higher
than 600 V with respect to earth!
• Never put the current clamp around any live wires if it is not connected to
a measurement device!
• When grasping cables or current busbars with the current clamp, make
sure that they are well-centered and perpendicular to the clamp!
• Keep the enclosed wire as far as possible from adjacent wires to prevent
distortions due to magnetical interference fields!
• When replacing the battery, the current clamp power switch has to be in
the "OFF" position and the clamp must be separated from busbar and
the measurement device!
• Do not use the current clamp if it is damaged or you detect indications of
a possible defect! This may be hazardous to life.