3.3 Mounting instructions
There are two possible ways for mounting
OTMC 100
.
Mast mounting using the delivered mast mounting
kit (see
Mounting instructions for mast
Temporary mounting using the 1/4" BSW
(British Standard Whitworth) thread for
mounting on a stand, for example.
3.3.1 Mounting instructions for mast mounting
The mounting kit delivered with
OTMC 100
contains the following parts:
•
1 mast clamp consisting of 2 clamping jaws and 4 fastening screws M6 x 110 with lock washers
•
2 clamping blocks and 4 fastening screws M6 x 16 with lock washers
•
1 connection pipe 20 x 300 mm
Proceed as follows:
Assemble the mast clamp and attach it to the mast as
shown in the figure.
The mast clamp is suitable for mast diameters of 25
to 70 mm.
Use a tightening torque of 5 Nm for the fastening
screws of the clamping block (1). The tightening
torque for the fastening screws of the mast clamp (2)
depends on the material and diameter of the mast.
1
2
OTMC 100 Quick Start Guide
10
OMICRON
