pag.8
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2017.05 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d’Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:[email protected]
2. Use in combination with the RADAR II 2CH and 4CH receiver
2.1 Programming
This procedure is necessary if you have received a transmitter and receiver(s) separately.
Before using a new TXF transmitter, communication has to be created between the transmitter and the
receiver(s).
To do this please follow the below described programming procedure.
ATTENTION: make sure the receivers have not already been programmed, if they have, cancel the program
and reprogram with the new transmitter.
1. Power up the receiver (insert the battery disconnector and any other switch that may be installed in
series with the receiver power supply);
2. On the transmitter: make sure the TX LED lights up when a function button is pressed in columns A,
B, C;
3. On the receiver: press the red emergency mushroom-head button: the buzzer inside begins to emit
a continuous sound;
4. On the receiver: put a magnet next to the “Learning Zone”: the buzzer inside the receiver
will emit an intermittent sound;
5. On the transmitter: press one of the function buttons (channel 1 Up/Down or channel 2 Up/Down)
in the column on which you wish to program the receiver (A, B or C).
6. On the receiver: the sound issued by the buzzer returns;
7. On the receiver: release by turning the red emergency mushroom-head button;
8. On the receiver: press the green button;
9. Make sure all functions connected to the radio remote control system are correctly activated.
RESET OR PROGRAM CANCELLING PROCEDURE
Each receiver stores up to 5 distinct transmitter codes. When the memory is full, the receiver signals it
by emitting an intermittent high frequency sound. To reset the memory, proceed as for programming up
to step 4 and keep the transmitter at hand. When the continuous beep switches to alternating beeps,
within 5 seconds the alternating beeps will emit a sound at a different frequency. Now, after releasing the
emergency button, press the green button on the receiver.
LEARNING ZONE
101-050
USER AND MAINTENANCE MANUAL
“RADAR NEW TXF”
Codice foglio: 997-101-50366 R
ev: //
Data: V
enerdì 16 giugno 2017
Codice fascicolo: 997-101-50370