pag.7
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2017.05 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d’Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:[email protected]
1.6 Replacing the batteries
The power batteries have to be replaced immediately when the BATT LED switches on and flashes quickly
while the function button is active and the TX LED is off.
To do this, move the catch downwards, lift the battery compartment cover and remove the flat batteries.
Replace them with two of the same type (AA 1.5V alkaline), taking care not to reverse the polarity (see
figure). Put the battery compartment cover back and lock with the catch.
If the battery is leaking liquid, immediately remove it and clean the battery compartment, making sure you
do not touch this substance; wash your hands thoroughly after this operation.
ATTENTION: Do not dispose of old batteries in the environment, but throw them into special
containers to facilitate disposal.
1.7 Emergency command from the transmitter
The RADAR TXF is fitted with Emergency command: whenever the emergency button is pressed on the
transmitter, an emergency signal is sent to all programmed receivers.
The emergency button dominates all other commands, thus the receiver stops any function active at that
time.
Pressure on the emergency command is signalled by the receiver, by the continuous sound of a buzzer
inside the receiver itself.
To restore proper operation of the system, press the Green start button on the receiver, the radio remote
control is ready to perform new operations.
Catch.
Pull downwards.
Battery compartment
cover
Remove the battery
upwards.
Negative pole (-)
Positive pole (+)
Positive pole (+)
Negative pole (-)
101-050
USER AND MAINTENANCE MANUAL
“RADAR NEW TXF”
Codice foglio: 997-101-50366 R
ev: //
Data: V
enerdì 16 giugno 2017
Codice fascicolo: 997-101-50370
