12
Changing Filters
Disposable
·
Prior to changing the filters, the water level in the tank must be no higher than the
level of the spray bar.
·
Filters should be changed periodically depending on the usage of the equipment and
the contaminants being removed. If water is not flowing more than a trickle from the
spray bar holes, it is time to replace your filters.
·
Individually unscrew counterclockwise the two (2) large blue filter cartridge holders.
The cartridges will be full of water.
·
Pour the water out of the cartridges and remove the filters. Be careful not to lose the
rubber O-ring gasket located on the inside of the filter cartridge. Absence of this
gasket will cause the filter(s) to leak.
·
Replace with new filter(s) and re-install the cartridges.
·
The 20 Micron Polycarbonate Filter is the primary filter and is located on the right
side of the filtration unit.
·
The 10 Micron Polycarbonate Filter is the secondary filter and is located on the left
side of the filtration system.
Reusable Stainless Steel
·
Clean the outside of the filters in a sink.
·
Place each filter into individual Ziplock bags.
·
Fill each bag with hot water and add soap from the bath.
·
Seal bag and place into ultrasonic tank and operate the ultrasound for 15 minutes.
·
Dump the fluid from the bag into the sink, NOT the ultrasonic tank.
·
Repeat the process until no dirt is extracted from the filters.
·
Replace the filters into the blue canisters.
**Note: Constant usage will cause filters to be changed out more often than the
complimentary ultrasonic tank.**
Summary of Contents for RESTORATION PRO 3600PW
Page 20: ......
