10
Pistons
In the ultrasonic bath, preheat 1 part OmegaSupreme with 10 parts clean water to a
temperature of 68˚C.
Place the piston, face down, in the basket and submerge the basket into the bath.
Presoak for 10 minutes. Once this is done, activate the ultrasound for 15 minutes.
Remove the piston and use a wire brush to knock off any heavy carbon deposits.
Submerge the basket into the bath gain, and clean for another 15 minutes.
Rinse thoroughly
NOTE: If aluminum scarring is present, stop the ultrasonic cleaning process.
Metal Parts
In the ultrasonic bath, preheat 1 part OmegaSupreme with 10 parts clean water to a
temperature of 66˚C.
Place the metal parts into the basket with the cavity containing heaviest residue facing
the bottom of the basket.
Submerge the basket into the bath and rotate the housings (if applicable) keeping them
underneath the surface to allow air bubbles to be removed from the part.
Clean the part for 5 minutes.
Once completed, rotate the part 180˚ if the part facing opposite the ultrasonic
transducers is heavily soiled.
If necessary, clean the part for an additional 5 minutes.
Once the part is cleaned, remove from the bath and rinse using water that is 150˚F.
Blow off the excess water using compressed air.
Due to the heat of the metal, after being removed from the bath, it will dry quickly, on
its own (“flash dry”).