Wiring
To access the screw terminals and wire the transducer, refer to Figure 2, and the following procedure.
1. Locate the screw at the top of the transducer and unscrew.
2. Separate connector from the rest of the transducer body. Remove the screw and rubber gasket from the connec-
tor and set aside.
3. Using a small blade screwdriver, insert it in the corner slot and pry off square cover (and terminals).
4. Insert cable into hole (not screw hole) and feed through into square part of assembly. Wire terminals in terminal
block using wiring diagram (refer to Figure 3).
5. Replace terminal block and snap in place.
6. Put rubber gasket on unit.
7. Connect larger part of transducer to wired unit observing positions of blades.
8. Insert screw in screw hole and tighten two parts to each other.
Figure 2.
Pressure Transducer
Figure 3.
Wiring Diagram
