1.3
Precautions
•
This device has not been designed, tested, or approved for use in any
medical or nuclear applications.
•
Never operate this device in flammable or explosive environments.
•
Never operate with a power source other than the one recommended in
this manual.
•
Never operate this device outside of the recommended use outlined in this
•
manual.
•
There are no user serviceable parts inside your device. Attempting to
repair or service your unit may void your warranty.
There are two pressure ports
– ensure the unused port is sealed before
operation. A set screw (provided) is used to block the unused port
. It is advised
to use thread sealant when installing the set screw.
For more information,
see section 2.2.
Section 2
– Setup
2.1
General Dimensions
All dimensions shown in inches.
2.2
Pressure Port Configuration
For convenience, the sensor has two pressure port locations that are 90° apart
from each other. Depending on the application, it is sometimes advantageous to
use one port over another.
As shown in the image on the next page, once a port has been chosen, the other
port must be blocked. A set screw (provided) is used to block the unused port
. It
is advised to use thread sealant when installing the set screw.
1-3
