High Setpoint
The next parameter encountered is for setting the high setpoint for
output 2
. The display will quickly flash “2H” and then it will display the
current value of the high setpoint.
To set the high setpoint, increment the current digit (flashing) by pressing the
adjusting
key
until the display matches the desired setpoint. The digit will reset
to zero (roll over) after nine has been reached in case the desired number has been
accidentally passed. To scroll to the next digit, press the
carry
key
. Once the
rightmost digit has been set, press the
setting
key
to go to the next parameter.
Low Setpoint
The next parameter encountered is for setting the low setpoint for
output 2
. The display will quickly flash “2L” and then it will display the
current value of the low setpoint. This value is entered exactly like the
high setpoint, discussed above. Once the rightmost digit has been set, press the
setting
key
to go to the next parameter.
3.2.8 Display Colors
The display color can be programmed to change based on
Output 1
high and
Output 1
low setpoints.
The next parameter encountered is display color based on
Out1
high
setpoint. Using the table below
, set the desired screen color based on the “
bH
x
”
number by using the
adjusting
key
. Once completed, press the
setting
key
to go to the next parameter.
Number
bH-1
bH-2
bL-1
bL-2
Color
Red
Green
The next parameter encountered is display color based on
Out1
low
setpoint. Using the table above, set the desired screen color based on
the “
bL
x
” number by using the
adjusting
key
. Once completed,
press the
setting key
to go to the next parameter.
3
-
2-
8
