Omega ORC97G, Instruction Manual

Page: 8 / 11

8
Maintenance
CLEAINING THE GREASE FILTER MESH
The filter mesh is made of high-density stainless steel. Please do not use corrosive detergent on it. Keeping
this filter clean will keep the appliance running correctly. Please follow the guidelines below.
Place the mesh in 40 –
50°C clean water, add in a small amount of detergent, and soak for 2 - 3 minutes.
Wear gloves, and clean with a soft brush. Do not apply too much pressure, as the mesh is delicate and will
damage easily.
The grease filters can also be put into a dishwasher. To do so, set the temperature at around 60 degrees.
CLEANING THE RANGEHOOD
• To protect the main body from corrosion over a long period of time, the cooker hood should be
cleaned with hot water and a non-corrosive detergent every two months.
• Do not use abrasive detergent as it will damage the body.
• Keep the motor and other spare parts free from water, as this will cause damage to the appliance.
• Before cleaning, unplug the appliance.
• If fitted with active charcoal filters, the charcoal filter should not be exposed to heat.
• Do not tear open the fixed bar around the active charcoal filter.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid hazards.
Replacing the Lights
Warning: Before attempting to change the lights, ensure that the appliance is
switched off and unplugged from the wall socket.
• Remove the grease filter.
• Press the spring on both sides of the LED light until the light falls out (Pic. 1).
Gently pull the light wire out and disconnect the terminal (Pic. 2).
• Reverse the procedure to replace the light. Use an identical light:
o LED modules – round lamp.
o Max Wattage: 2 x 1.5W
o Voltage Range: 12V DC
o ILCOS D Code: DSR-1.5/65-S-64
• Replace the grease filter.