Omega ORC97G, Instruction Manual

Page: 7 / 11

7
Installation Instructions
Fig. 06 Fig. 07
Note : Fix the Canopy with safety screws. See Pic 5. The two safety screw holes are positioned on the back
casing, with a diameter of 6mm.
Warning : Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards.
Operating Instructions
The re-usable aluminium grease filters supplied with this rangehood should be cleaned every month or so
to avoid grease build-up.
To remove the grease filter, release the locking mechanism at the front of the filter, and lower the filter
slightly to unhook it at the back. Whilst the filter is removed, clean off any residual grease from the housing
to avoid fire risk.
When replacing the grease filters, ensure that the locking mechanism is facing down.
If the rangehood is used in re-circulation mode, the activated charcoal filter must be in place. These
charcoal filters are designed to absorb cooking odours and are located in the canopy above the grease
filters. Before fitting or replacing charcoal filters, the grease filters must first be removed.
CONTROLS
1. 1. Push the ‘Power’ button to turn the unit on and off.
2. 2. Push the ‘Low’ button to set the extraction fan to low speed.
3. 3. Push the ‘Mid’ button to set the extraction fan to medium speed.
4. 4. Push the ‘High’ button to set the extraction fan to high speed.
5. 5. Push the ‘Light’ button to turn the light on and off.
Low Mid High Light Power
Fig. 08