Channel 11 Channel 12 Channel 13 Channel 14
Channel 15 Channel 16 Channel 17 Channel 18
Channel 19 Channel 20 Channel 21 Channel 22
Channel 23 Channel 24 Channel 25 Channel 26
(not supported)
Deploying and Activating Devices
Step 1:
Plug the OM-CP-RFC1000 into the USB port on the base station computer.
(Additional OM-CP-RFC1000s can be used as repeaters to transmit over greater distances)
Step 2:
If using multiple OM-CP-RFC1000s plug each one into a wall outlet in the desired locations.
(If transmitting over a distance greater than 1000 feet indoors or 4000 feet outdoors or there are walls/
obstacles/corners that need to be maneuvered around, set up additional OM-CP-RFC1000s as needed.)
If not using multiple OM-CP-RFC1000s, go to step 3.
Step 3:
Verify that the data loggers are in wireless transmission mode by confirming the wireless ON /
OFF switch is in the ‘1’ position on each data logger.
(See Channel Programming steps above)
Step 4:
On the PC, launch the Omega Data Logging software. All active data loggers will be listed in the
software showing that the device(s) are recognized.
Step 5:
To activate your data loggers, click on one to highlight, then right click to select the desired
Start
method. Do this for each logger in your list that you wish to activate.
Quick Start Manual
The default wireless channel for Omega
wireless devices is channel 11. Different
wireless channels may be used to create
multiple networks in one area, or to avoid
wireless interference from other devices.
The images below show the orientations
avaliable of the switches for each channel.
Channel 26 (all switches in the up position)
is not supported.
See examples to the left.
