20
Maintenance and Cleaning
Cleaning And Maintenance of the Oven’s Front Door Glass
Remove the profile by pressing the plastic latches on both left and right sides as shown in figure 20 and
pulling the profile towards yourself as shown in figure 21. Then remove the inner-glass as shown in figure
22. If required, the middle glass can be removed in the same way. After cleaning and maintenance is done,
remount the glass and the profile in reverse order. Make sure the profile is properly seated in its place.
Figure 20
Figure 21
Figure 22
Rack Positions
It is important to place the wire rack into the oven properly. Do not allow wire rack to touch the rear wall of
the oven. Rack positions are shown in the above image. You may place a deep tray or a standard tray in
the lower and upper wire racks.
Installing and removing wire racks
To remove the wire racks, press the clips and first remove the lower and then the upper side from the
mount. Reverse the procedure to replace the wire racks.
Changing the Lamp
WARNING
: Disconnect the appliance from the power supply and ensure that it is cold before changing the
lamp.
•
Unscrew the glass protective cover.
•
Remove the lamp by turning it; install a new lamp with the same specifications.
•
Reinstall glass protective cover, plug the power cable of appliance into electrical socket
and complete replacement.
Type G9 Lamp
Type E14 Lamp
220-240 V, AC
15-25 W
Figure 23
220-240 V, AC
15 W
Figure 24
