9
5) GAS CONNECTION
The gas connection is located in the rear and on
the right hand underside of these appliances:
(100 mm mod: OCG755FX)
There are two ways to carry out the connection to the
main gas line:
A.
The hotplate can be connected with rigid pipe as
specified in AS/NZS 5601.
B.
If installing with a hose assembly, install with a
hose assembly that complies with AS/ANZ 1869
(Australian Certified), 10 mm ID, class B or D, no
more than 1.2 m long and in accordance with
AS/NZS 5601. Ensure that the hose does not
contact the hot surfaces of the hotplate, oven,
dishwasher or any other appliance that may be
installed underneath or next to the hotplate. The
hose should not be subjected to abrasion, kinking
or permanent deformation and should be able to be
inspected along its entire length with the hotplate in
the installed position.
Unions compatible with the hose fittings must be
used and all connections tested for gas leaks.
The gas supply connection point must be
accessible with the appliance installed.
Natural Gas
Natural Gas installations require the connection of a
gas regulator at the appliance.
Assemble the regulator (noting the gas flow
direction) and transition piece, in accordance with
figure 11.
The transition piece on the supply side of the
regulator must be provided by the installer.
Liquified Petroleum Gas
In a U-LPG installation, the gas pressure regulation
is provided at the supply cylinder located outdoors,
and an additional regulator at the appliance is not
required.
To connect supply to the appliance use transition
pieces as shown in figure 11/A. These pieces are
supplied with the appliance on purchase.
WARNING:
THE BURNER FLAME MUST BE ADJUSTED BY
THE INSTALLER.
FAULTY INSTALLATION WILL NOT BE
COVERED UNDER WARRANTY.
THE APPLIANCE IS FACTORY SET FOR NATURAL
GAS. THE TEST POINT PRESSURE SHOULD BE
ADJUSTED TO 1.00kPa WITH THE WOK BURNER
OPERATING AT MAXIMUM.
INSTALLATION
FIG. 11
FIG. 11/A
