8
Operating Instructions
Ceramic Heater
The ceramic heater is controlled by a 6 position knob.
The ceramic heater is operated by turning the control knob to the required setting.
Near each control knob is a symbol which indicates the heater that is controlled by that knob. The on/off
light on the control panel will show if any of the ceramic heaters are in use.
Knob Position
Function
0
Off position
1
Keep warm position
2-3
Heating position at low heat
4-5-6
Cooking, roasting and boiling
position
Residual Heat Indicator
After using the hob there will be heat stored in the vitro-ceramic glass called residual heat. If the residual
heat level is greater than +60°C, the residual heat indicator will be active for the cooking zone which is
above this temperature.
If the power supply to the hob is disconnected while the residual heat indicator is on, the warning light will
flash when the power is reconnected. The display will flash until the residual heat has decreased or until
one of the cooking zones is activated.
9
Operating Instructions
Hints and Tips
Important: When ceramic heaters are operated in higher heat settings, the heated areas may be seen
switching on and off. This is due to a safety device which prevents the glass from overheating. This is
normal at high temperatures, causing no damage to the hob and little delay in cooking times.
WARNING:
•
Never operate the hob without pans on the cooking zone.
•
Use only flat saucepans with a sufficiently thick base.
•
Make sure the bottom of the pan is dry before placing it on the hob.
•
While the cooking zone is in operation, it is important to ensure that the pan is centred correctly
above the zone.
•
In order to conserve energy, never use a pan with a different diameter to the hotplate being
used.
•
Do not use pans with rough bottoms since these can scratch the glass ceramic surface.
•
If possible, always place lids on the pans.
•
The temperature of accessible parts may become high while the appliance is operating. Keep
children and animals well away from the hob during operation and until it has fully cooled after
operation.
•
If you notice a crack on the cooktop, it must be switched off immediately and replaced by
authorised service personnel.
