6
Installation Instructions
Installation of the Hob
The appliance is supplied with an installation kit including adhesive sealing material, fixing brackets and
screws.
•
Cut the aperture dimensions as indicated in the figure. Locate the aperture on the worktop so
that, after the hob is installed, the following requirements are followed.
B (mm)
590
min. A (mm)
50
T (mm)
520
min. C (mm)
50
H (mm)
41-47.5
min. E (mm)
500
C1 (mm)
560
min. F (mm)
10
C2 (mm)
490
G (mm)
20
D (mm)
50
I (mm)
25
J (mm)
5
•
Apply the supplied one-sided self- adhesive sealing tape all the way around the lower edge of
the cooktop. Do not stretch the tape.
•
Screw the 4 worktop mounting brackets on to the side walls of the appliance.
•
Insert the appliance into the aperture.
7
Installation Instructions
Electrical Connection
LOCAL AUTHORITY REQUIREMENTS
Installation is only permitted by a licensed electrician, and carried out according to instructions
provided by the manufacturer. Incorrect installation might cause harm and damage, for which the
manufacturer accepts no responsibility.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage,
and the mains electric wiring should be capable of handling the cooktop’s power rating (also indicated on
the identification plate). If you have any doubts, call in a qualified technician.
NOTE: For connections to the mains power supply, never use adapters, reductions or multiple power points
as these may overheat and catch fire. Do not install separate timers.
After having installed the appliance, the switched outlet must always be in an accessible position.
The electrical safety of this appliance can only be guaranteed if the cooktop is correctly and efficiently
earthed, always ensure that the earthing is efficient; if you have any doubts call in a licensed electrician to
check the system. The manufacturer declines all responsibility for damage resulting from an installation
which has not been correctly earthed.
WARNING: If any damage occurs to the power cable during or after installation, it must be replaced
immediately by a licensed electrician with a replacement cable from your Service Centre.
The cooktops are to be connected to a single phase 230-240Vac 50 Hz supply. They are earthed via the
cable.
The mains terminal block is located on the underside of the cooktop and the terminals are accessible by
removing the terminal block cover by removing the cover screw. Connect the appliance as shown in the
diagram to the right.
The appliance is designed for fixed connection to the mains. During installation, an all pole disconnector
should be included inside they supply circuit with a contact opening of at least 3mm (rated 32A, delay
functioning type). The power supply cord must not touch against any hot surfaces and must be placed so
that its temperature does not exceed 75 °C at any point along its length.
IMPORTANT: The appliance must NOT be connected to the mains supply by means of a 10A or 15A plug
and socket.
