![background image](http://html1.mh-extra.com/html/omega/monza-ttg15t/monza-ttg15t_user-manual_3982990034.webp)
34
EN
6. PROBLEM SOLVING
In case of any serious problem, the user should consult the appropriate technical service for the repair and overhaul of the
machine. This troubleshooting guide is intended to prevent you from going to your technical centre for easy-to-solve solutions.
Problem
Solution
Cylinder rod does not move
SOLUTION: A, D, E, H, J
Slow speed of the cylinder shaft when extending or retracting
SOLUTION: A, B, C, H, I, K, L
Wood does not break or breaks extremely slowly
SOLUTION: A, B, C, F, I, K
Engine stalls during splitting
SOLUTION: G, L
Engine stalls at low load conditions
SOLUTION: D, E, L, M
Posible cause
Solution
A- Insufficient oil to pump
Check the oil level in the tank
B- Air in oil
Check the oil level in the tank
C- Excessive pump inlet vacuum
Check that the pump inlet hose is not blocked or kinked.
D- Hydraulic hoses blocked
Flush and clean the hydraulic system of the splitter.
E- Control valve blocked
Flush and clean the hydraulic system of the splitter.
F- Low control valve setting
Adjust the control valve with a pressure gauge
G- Control valve high setting
Adjust the control valve with a pressure gauge
H- Control valve damaged
Send the control valve for repair
I- Internal leakage of the control valve control valve
Send the control valve for repair
J- Internal cylinder leakage
Send the control valve for repair
K- Cylinder internally damaged
Send the control valve for repair
L- Out of adjustment engine control
Adjust the idle control nuts
M- Engine charging during idle mode
Use a shorter trunk (20” or less) to allow the engine to accele
-
rate before contact.
Summary of Contents for MONZA TTG15T
