Page - 14
SecureCode:
“SecureCode” allows the user to customize the number of Valet Switch presses
which are required to successfully perform an Emergency Override. The basic Emergency Override
procedure is described on page 11. Instead of a single “1 press” of the Valet Switch which would
be required in order to perform an Emergency Override, two stages of Valet Switch presses must be
made. In each of the two stages, the Valet Switch will need to be pressed 1 through 9 times, as
programmed by the user. This is the Emergency Override procedure if the system has programmed with
a customized SecureCode:
described on page 11, enter the vehicle (the system will most likely activate or already be activated to
a triggered alarm condition. Using the ignition key, turn the vehicle’s ignition switch on, and within
5 seconds press and release the Valet Switch. The system will disarm.
Once the system is disarmed, if Valet Mode is desired, just press and hold the Valet Switch for 2
seconds to place the system into Valet Mode. Should a mistake be made entering the SecureCode, after
Step 1
With the system in the armed condition, enter the vehicle via the driver's door (be aware that
the system will activate to an alarm condition when the door is opened).
Step 2
Using the ignition key, turn the vehicle’s ignition switch on.
Step 3
Within 5 seconds press and release the Valet Switch the same number of times that have been
programmed for stage #1.
Step 4
After a few seconds, the siren will stop sounding, chirp once, and then resume sounding.
Step 5
Now, within 5 seconds press and release the Valet Switch the same number of times that have
been programmed for stage #2. Within a few seconds the siren will stop sounding, and the unit
will disarm.
Page - 27
Feature #9 Ignition Off Unlock #2
(Factory Default Setting Off)
Explained in the previous feature, if Driver’s Door Priority is installed this feature controls the
automatic unlocking when the ignition key is turned off of all doors except the driver’s door.
Feature #10 Open Door Bypass of Ignition Locking
(Factory Default Setting On)
This feature cancels the automatic locking or unlocking of the vehicle’s doors should one of the doors
is open when the ignition switch is turned on or off.
Feature #7 Doors Lock With Ignition On
(Factory Default Setting On)
This feature has the system automatically lock the vehicle’s doors every time the ignition key is turned
on. An exception would be if feature #10 is turned on (“Open Door Bypass of Automatic Locking”),
and a door is open when the ignition key is turned on.
Feature #8 Ignition Off Unlock #1
(Factory Default Setting On)
Similar to the previous feature, this feature automatically unlocks the vehicle’s doors every time the
ignition key is turned off, with the same exception regarding a door being open when the ignition is
turned off, and feature #10 being on. On Crime Guard models with “Driver Door Priority Unlocking”,
this feature may control all doors’ unlock operation, or only the driver’s door. If the later, the next
feature controls the ignition key unlocking of the remaining doors.
Feature #11 Confirmation Chirps
(Factory Default Setting On)
This feature removes the system’s 1 arming chirp and 2 disarming confirmation chirps. When this
feature is used to remove these chirps, the system will still have 3 chirps upon arming if a protected zone
is violated, and still have 4 chirps upon disarming if the system was previously activated. Using this
feature to turn off the arm and disarming chirps will also not affect the Prewarning operation, Unauth-
