![background image](http://html1.mh-extra.com/html/omega/hh800-sw/hh800-sw_instruction-sheet_4146206004.webp)
6. Explanations of Toolbar
6.1
Communication port
setup
dialog
box.
•
Auto connection
: Click the bottom let sys-
tem select communication port automati-
cally.
•
Manual connection
Select communication port and baud rate
manually. (Wireless mode, please select
38400 bps, USB mode, please refer to op-
eration manual).
After click on “Do not show this window
automatically” it will not bring up the
dialog box automatically. It will only
function when you call from the Setup.
For first use, after communication port
setting following dialogue box comes up.
•
Set meter ID and CH (Only for wireless
models)
1. When message “Meter is found on
CH=00, ID=00” is shown in dialogue
box.
Please change ID and CH numbers to
other numbers preferred (ID from 1 to
127, and CH from 1 to 50).
(Model HH8XXE: CH from 1 to 4).
Click “Set” to connect.
2. When message “Meter not found on
CH=00, D=00” is shown in dialogue
box, please reset ID and CH as follow-
ing:
I.
Turn off the meter.
II.
Press and hold wireless starting key
(
) and press power on/off
key (
)for longer than five sec-
onds. Display will shown “00”.
III.
Turn on wireless function by press-
ing wireless starting key (
).
IV.
Click “Relink”.
V.
Repeat 1.
Note
If there are more than one wireless
transceivers operate at same location.
1. Different doungle ID’s should be
given.
2. Distance between 2 doungles must be
more than 30 cm. (12 inches)
6.2
Environment selection settings dialog
box.
•
Time setting
Only available for meters with time set-
ting function.
Click “SET” synchronize the clock in me-
ter with the time of PC.
•
Doungle ID setting
Only available for meters with wireless
function.
•
Meter ID and CH setting
CH setting only available for meters with
wireless function.
•
Sound of Hi/Lo limit setting
Click data folder icon on the right
,
and select sound effect. (Only use WAVE
format).
•
Hi/Lo limit setting
1. Setting the Limits.
Audio alarm will be actuated, when
measurements are out of limits.
2. Background color of each channel can
be selected.
Enable or disable the function which stop
data logging when battery is low.
6.3
Relative dialog box.