background image

Feature #17: 30 / 60 Second Activated Alarm Cycle

(Factory Setting 60 Seconds (ON)

Feature Turned On: Upon activation, the siren will sound and the parking lights
will flash for 60 seconds.
Feature Turned Off: Upon activation, the siren will sound and the parking lights
will flash for 30 seconds.

Please note that the shorter 30 second activated time may be required in some

localities to comply with noise nuisance ordinances.

Feature #18: Pulsed Horn / Steady Siren Output

(Factory Setting Steady Siren (OFF)

Feature Turned On: This Feature allows the use of the vehicle's horn in place of
the electronic siren for the audible output of the security system. When configured
for use with a horn, this output pulses for 10 seconds, then pauses for 5 seconds,
repeating this cycle for the duration of the activated alarm period. This prevents
the horn from overheating, thereby ensuring a maximum useful life to the vehicle
owner.
Feature Turned Off: The output is a continuous, steady output which the elec-
tronic siren requires. The siren features six different siren tones, which change
every 5 seconds.

Page - 36

Feature #19: Loud / Soft Pulsed Horn Chirps       (Factory Setting Loud (ON)
Feature Turned On: 12 Millisecond Confirmation Honks.
Feature Turned Off: 8 Millisecond Confirmation Honks.
If your security system is configured to use the vehicle's horn, this Feature allows
a degree of compensation for the variance which is found in the length of the pulse
required to honk the horn in a satisfactory manner.

Feature #20: Total Closure Lock Output                       (Factory Setting OFF)
Feature Turned On: 28 Second Doorlock Output.
Feature Turned Off: .8 Second Doorlock Output.
If the vehicle is so equipped, this Feature allows the installer to take advantage of
a preexisting Total Closure System.

Feature #21: Remote-Activated Anti-Carjacking Protection

(Factory Setting OFF)

Feature Turned On: Anti-Carjacking Protection Feature Activated By 3rd
Channel Output. 
This Feature allows remote activation of the Anti-Carjacking
Feature. If this Feature is turned ON, pressing the Small Left Button on the trans-
mitter for 3 seconds will activate the Anti-Carjacking Feature, but only when the
ignition switch is "on". This Feature may be activated regardless of the setting of
Features #1 and #2 (Ignition and Door Activated Anti-Carjacking Protection).

Page - 37

Feature Turned Off: 3rd Channel Will Not Operate Anti-Carjacking.

Feature #22: One / Two Button Arming / Disarming

(Factory Setting One Button (ON)

Feature Turned On: One Button Arming / Disarming. This Feature controls
how the transmitter operates the security system. If this Feature is turned ON, the
transmitter's Large Center Button will alternate arming and disarming the system
with each press of the button.  This type of operation is also described as a "single
button toggle" for the arming and disarming of the system.
Feature Turned Off: Two Button Arming / Disarming. Having this Feature set
to the OFF setting causes the system to operate in a "dedicated button for arming
and dedicated button for disarming" fashion.  This Feature's "Two Button" setting
may be used with the standard 3-button transmitter; when configured in this fashion
the large center button arms the system, and the small right button disarms the
system.  Pressing the small right button operates trunk release; pressing the large
center button and small right button together operates the 3rd channel output.

Enhanced "Panic" operation: Having feature #22 configured for "Two Button
Arming / Disarming"  enhances the "Panic" feature's operation; using the "arm"
button activates "Panic" with an armed system, locking the doors, and using
"disarm" button results in "Panic" with a disarmed system and unlocked doors.

Page - 38

Page - 39

Transmitter Options

Feature #22 configured for
"Two Button Arming / Disarm-
ing" with supplied transmitter

Disarms
system, and
engages
"panic"
with
system
disarmed

Operates
2nd channel
 output

Operates
3rd channel
 output

AL-1000ATV2 

434MHz w/Green LED (#103-03)

AL-900ATV2 

302MHz w/Red LED (#109-03)

Arms system, and engages
"panic" with system armed

Optional 4-button transmitter with
Feature #22 configured for "Two
Button Arming / Disarming"

J

J

J

II

II

OUTPUT

III

Arms system, and
engages "panic"
with
 system
armed

Disarms system, and
engages "panic" with
                  system
                 disarmed

Operates
3rd channel
 output

Operates

2nd channel

 output

Optional 4-button trans-
mitter for AL-1000ATV2
only; part number #105-07

Summary of Contents for Excalibur AL-1000ATV2












Reviews: