8
9
The white LED will indicate that Bluetooth mode has been
activated. When the button is held down, it will initially
be lit, then will go out before starting to flash after four
seconds. The button can then be released. The rotating
winder can now be detected with a Bluetooth device.
It will remain in this mode for one minute. If no computer
has connected to it within this time (Bluetooth connection
established and interface paired), the winder will revert
to standard mode and resume its cycle.
Connecting to the rotating winder requires a computer
(PC or Mac) with an installed Bluetooth peripheral (dongle
or integrated module). The access code to establish the
connection is: 1234 (requested at the first connection only).
Launch the application and a window will appear:
“Welcome to Cylinder Configuration Tool”.
Then press the “Open” button to launch the detection of
the rotating winder. This will only succeed if the winder
is properly connected to the computer. Once the appli-
cation has been located and connected, the winder will
remain in Bluetooth mode as long as the application
stays open. If the application is closed, or if the winder
is disconnected, it will revert to its normal mode. If the
ON/OFF button is pressed while the Bluetooth mode is
active, the rotating winder will switch off immediately,
whether the application is connected or not.
2.5 BATTERY POLARITY
3. BLUETOOTH CONFIGURATION
3.1 ACTIVATING BLUETOOTH MODE
Before activating the Bluetooth mode on the rotating
watch winder, download the application “OMEGA
LE CYLINDER” to your computer. It can be found at:
www.omegawatches.com/omega-lecylinder.
By default, the Bluetooth mode of the rotating winder
is deactivated, making it invisible to other Bluetooth
devices. To activate the Bluetooth mode, hold down the
ON/OFF button for more than four seconds. Activation
can only be done when the winder is switched off.
