2.2 Mounting the Recorder on the Wall
To mount the recorder on the wall, first locate the wall mounting holes using the
template provided in the wall mounting kit. Leave the decorative foot cover
(Figure 1-1, item #18) in place*. After drilling the holes, insert the wall anchors
and put in the screws, leaving
1
⁄
8
inch (3 mm) between the screw heads and the
wall. Hang the recorder by positioning the two (2) “keyholes” in the rear cover
over the screw heads.
The ac adaptor has a 6 foot (2 meter) cable.
* If the decorative foot cover is not in place, go through the following steps to
reinstall the cover (if desired):
1.
Place the recorder on the table (so it is front face up).
2.
Roughly position the foot cover so the clips are in line with the stabilizing
arm. Gently “stretch” the clips out and position over the arm as shown in
Figure 2-4a.
3.
Once the clips are in place, gently slide down until the foot cover is even
with the front of the recorder as shown in Figure 2-4b.
Figure 2-4a. Installing the Foot Cover
Figure 2-4b. Installing the Foot Cover (Side View)
(Top View)
Clip
Cutaway View
Clips
RH
°
F
°
C
H35 T2
T
E
M
P
E
R
A
T
U
R
E
H
U
M
I
D
I
T
Y
NOTE
Setting Up the Recorder
2
2-3
Summary of Contents for CT485B-110V-G-AL
