4.5.3.2 Network-to-Serial
For units
with -EIT
option the
RS485
Serial Port
tab will not
be part of
web page.
Figure 4.7 iServer SERIAL Page – Network to Serial
Local Port –
This is the port number assigned to the iServer’s serial port for the
purpose of TCP, UDP, or ModbusTCP connection. Any number between
500
and
9999
can be used with the exceptions of
1000
and
2002
which are reserved by the
iServer for other purposes (port
1000
is described in the previous section and port
2002
is the iServer’s Telnet console port). The default is
2000
.
Port number
502
is the default port number for Modbus/TCP protocol.
If Modbus/TCP is enabled in the iServer, set port 502 as the iServer’s Local
Port .
Disconnect after Data Sent –
If checked, the iServer receives a command, sends it
to the serial port and waits for a reply. If a reply is recieved it will close the
connection.
19
Summary of Contents for C4EIT
Page 2: ......
