While the AL-100-H is armed, the Red LED Status Indicator will be flashing. In
addition to visual deterrence, the LED Status Indicator shows events that have occurred or
actions that will take place in the system's operation. It is normally mounted in a
conspicuous location easily seen from outside the vehicle.
The Starter Interrupt output will also activate. The Starter Interrupt will prevent the
engine from starting when an attempt is made to start the engine. To minimize battery drain,
this device does not draw electrical current unless the ignition switch is turned to the "Start"
position.
While armed, the AL-100-H monitors all protected circuits for an intrusion attempt. If
an optional sensor is utilized, the sensor will also be activated to monitor intrusion attempts.
Sensors are available which include those that monitor shock to the vehicle, detect changes
in atmospheric pressure within the vehicle, and radar sensors that can detect motion inside
and outside the vehicle.
S y s t e m A r m e d
Page - 7
usually located in unabtrusive location accessible to the driver. In addition to providing a
method to disarm the system without the transmitter, this switch also enters the AL-100-H
into Valet Mode, which is discussed on Page 9. To disarm, follow this procedure:
STEP 1. With the system in the armed condition, enter via the driver's door (be
aware that the security system will trigger the instant the door is opened,
sounding the horn or optional siren and flashing the parking lights).
STEP 2. Use the ignition key to turn "on" the ignition switch.
STEP 3. Within 5 seconds, press the Easy Valet Switch. The security system will
instantly disarm.
While the AL-100-H is armed, the Red LED Status Indicator will be flashing. In
addition to visual deterrence, the LED Status Indicator shows events that have occurred or
actions that will take place in the system's operation. It is normally mounted in a
conspicuous location easily seen from outside the vehicle.
The Starter Interrupt output will also activate. The Starter Interrupt will prevent the
engine from starting when an attempt is made to start the engine. To minimize battery drain,
this device does not draw electrical current unless the ignition switch is turned to the "Start"
position.
While armed, the AL-100-H monitors all protected circuits for an intrusion attempt. If
an optional sensor is utilized, the sensor will also be activated to monitor intrusion attempts.
Sensors are available which include those that monitor shock to the vehicle, detect changes
in atmospheric pressure within the vehicle, and radar sensors that can detect motion inside
and outside the vehicle.
S y s t e m A r m e d
Page - 7
usually located in unabtrusive location accessible to the driver. In addition to providing a
method to disarm the system without the transmitter, this switch also enters the AL-100-H
into Valet Mode, which is discussed on Page 9. To disarm, follow this procedure:
STEP 1. With the system in the armed condition, enter via the driver's door (be
aware that the security system will trigger the instant the door is opened,
sounding the horn or optional siren and flashing the parking lights).
STEP 2. Use the ignition key to turn "on" the ignition switch.
STEP 3. Within 5 seconds, press the Easy Valet Switch. The security system will
instantly disarm.
P r o g r a m m a b l e F e a t u r e s
Your AL-100-H security system has six programmable features that allow your system
to be customized to fit your personal needs. These features are selectable by Dual Inline Pin
(DIP) switches inside the security system control module. Please see your dealer or installer
for more details, as we recommend that the installer change any of the following features:
1) Horn Honk Or Siren Chirp Confirmation On Or Off: With this feature is turned ON,
when the security system is armed and disarmed the horn will honk or the optional siren
will chirp to confirm that the system has responded to command from the transmitter.
With this feature turned OFF, there will be no confirmation honks or chirps. Turning
this feature OFF does not affect the optional Prewarning feature.
2) The Doors Will Also Lock With Automatic Last Door Arming: With this feature
turned ON,
when the security system passively arms from the Last Door Arming feature,
the doors will also lock if an optional doorlock interface was added. This will occur when
the system becomes fully armed 30 seconds after closing the last door.
3) Automatic Last Door Arming: With this feature turned ON the security system will
arm itself automatically when the vehicle's last door is closed. At the moment the last
door is closed the horn will honk or the siren will chirp, the exterior lights will flash once,
and the Status LED will flash fast. Thirty seconds later the siren will chirp once again,
the lights will flash, and the Status LED will flash slow, indicating that the security
system is fully armed. If feature #2 is selected, the doors will also lock. If the negative
instant trigger is grounded at any time during the thirty second countdown (Example:
opening the trunk), the Automatic Last Door Arming feature will be interrupted. When
the negative instant
Page - 14
P r o g r a m m a b l e F e a t u r e s
Your AL-100-H security system has six programmable features that allow your system
to be customized to fit your personal needs. These features are selectable by Dual Inline Pin
(DIP) switches inside the security system control module. Please see your dealer or installer
for more details, as we recommend that the installer change any of the following features:
1) Horn Honk Or Siren Chirp Confirmation On Or Off: With this feature is turned ON,
when the security system is armed and disarmed the horn will honk or the optional siren
will chirp to confirm that the system has responded to command from the transmitter.
With this feature turned OFF, there will be no confirmation honks or chirps. Turning
this feature OFF does not affect the optional Prewarning feature.
2) The Doors Will Also Lock With Automatic Last Door Arming: With this feature
turned ON,
when the security system passively arms from the Last Door Arming feature,
the doors will also lock if an optional doorlock interface was added. This will occur when
the system becomes fully armed 30 seconds after closing the last door.
3) Automatic Last Door Arming: With this feature turned ON the security system will
arm itself automatically when the vehicle's last door is closed. At the moment the last
door is closed the horn will honk or the siren will chirp, the exterior lights will flash once,
and the Status LED will flash fast. Thirty seconds later the siren will chirp once again,
the lights will flash, and the Status LED will flash slow, indicating that the security
system is fully armed. If feature #2 is selected, the doors will also lock. If the negative
instant trigger is grounded at any time during the thirty second countdown (Example:
opening the trunk), the Automatic Last Door Arming feature will be interrupted. When
the negative instant
Page - 14
