Black/White Wire - Domelight Supervision Output:
The Black/White
wire is intended, by configuring an optional SPDT relay, for Domelight Supervision. This
feature will illuminate the interior lights of the vehicle upon disarm (and also duplicate the
confirmation flashes). This output's operation is very similar to the White Parking Light
Output wire. If required, this output may be used instead, in conjunction with the White
wire, to operate European-style split parking lamp circuits.
As noted previously in the sections explaining the Green Negative and Violet Positive
Door Trigger Wires, the utilization and connection method of this output, in some cases, can
affect Parking Light Confirmation and Doorlocking operations. First, upon disarming, if
this output is connected to either door trigger wires, the Parking Lights will stay on for 10
To 12 Volt
Positive
Black/White
Wire
System
Control
Unit
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
Standard Configuration Of An
Optional SPDT Relay For
Domelight Supervision.
(-) Or (+) Factory Domelight Wire
To (-) Or
(+) As
Configured.
Dome
Light
85
86
87a
87
C O I L
30
To (-) Or (+)
As Needed
This connection may made at
the same point that Green
or Violet wire is made.
Page - 21
Continued Page 24
seconds instead of 30 seconds. Second, if the door is opened, activating an armed system,
if this output is connected to either door trigger wires, the doors will not automatically relock
until the activated alarm cycle has ended, providing that the doors are closed at that time.
In both cases the Domelight Supervision circuit is detected by the system as an open door.
CONNECTION: Connect the Black/White wire to an optional SPDT relay's pin #85.
Relay pin #86 is connected to Positive 12 Volts, and pin #30 is connected to the vehicle's
domelight wire. Relay pin #87 will be connected to 12 volts Positive (if the Violet Door
Trigger wire is used), or Negative Ground (if the Green Door Trigger is used).
If separation of the Door Trigger and Domelight Supervision is desired Pin #87a is also
used, as shown in the Enhanced Configuration diagram:
85
86
87a
87
C O I L
30
To 12 Volt
Positive
Black/White
Wire
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
Enhanced Configuration Of An
Optional SPDT Relay For
Domelight Supervision.
(-) Or (+) Factory Domelight Wire
To (-) Or
(+) As
Configured.
Dome
Light
To (-) Or (+)
As Needed
System
Control
Unit
To Control Unit's
Green Or Violet
Door Trigger
Wire
Page - 24
Summary of Contents for INSTALLATION MANUAL
Page 2: ...Page 43 Page 2...
