Step 1:
Install 6 each “T” nuts into the back of the
mounting board into the counterbored holes.
Hammer them flush to the surface (See figure
1).
Step 2:
Draw a level line on the wall centered where
the Range Hood is to go 6 9/16” above where
the bottom of the Range Hood will be (See
figure 2). A distance of 24-30 inches from the
stove top to the wood hood is recommended.
Check local building codes and regulations for
final determination.
Step 3:
Screw the mounting plate to the wall match-
ing the bottom of the mounting board to the
line on the wall. Make sure to hit at least two
studs and to use at least 6 screws of sufficient
size and length for the application (See figure
3).
Warning
: Failure to fasten this panel to studs
or using the wrong screws may cause a failure
of the mounting system and possible injury.
Assembly Instructions
Assembly Instructions
Figure 1
Figure 2
Figure 3
Step 4:
Start 6 each 10-24 x 3/4” screws into the “T”
nuts that were previously installed (See figure
4).
Figure 4
Form OME-087, 09/2012
©Omega National Products
10-0570-2
