4
!
WARNING
•
Study, understand, and follow
all printed
materials provided with/on this product
before
use
.
• Use
only
on hard, level surface.
•
Do not
exceed rated capacity.
• Lift and support
only
on areas of the vehicle as
specified by the vehicle manufacturer.
• Center load on saddle.
• No alterations shall be made to this product.
SERVICE JACK:
•
This is a lifting device only!
•
Immediately
after lifting, support the load with
a pair
of appropriately rated jack stands.
• Do not move or dolly the vehicle while on the
jack.
JACK STANDS
:
• Rated capacity of
jack stands
is
PER PAIR!
• Use as a matched pair to support one end of a
vehicle only. Use only
ONE (1) PAIR
per vehicle.
• Jack stands are not to be used to simultaneously
support both ends or one side of a vehicle.
FAILURE
TO HEED THESE MARKINGS MAY
RESULT
IN
PERSONAL INJURY AND/OR
PROPERTY DAMAGE
To avoid
crushing and related injuries
:
•
Never
work on, under or around a load supported
only by hydraulic jack.
•
Always
use adequately rated jack stands.
• Chock each unlifted tire in both directions.
•
Do not
use this device to lift, level, lower, support
nor move a house, mobile home, travel trailer,
camper or any building structure.
•
Be alert
and
sober
when using this product. Do not
operate under the influence of drugs or alcohol.
!
WARNING
X
OPERATION
Lifting
Only attachments and/or adapters supplied
by the manufacturer shall be used.
Use
jack stands
only
on areas of the vehicle
as specified by the vehicle manufacturer. Use
ONLY
on vehicles whose support points are
compatible
with the saddle of the jack stand. Incompatibility may
result in structural damage to the vehicle and/or jack
stand. Structural damage to either may result in sudden
and unexpected loss of load height!
1. Follow vehicle manufacturer’s recommended
guidelines for lifting. Engage the emergency brake
and chock each unlifted wheel in both directions to
prevent inadvertent vehicle movement.
2. Set up jack stands:
a. Adjust height by pulling up the ratchet bar.
b. The weight of locking handle should secure the
ratchet bar in desired position. To confirm this,
Simply push down on the locking handle.
3. Close release valve by turning the handle clockwise until
firm resistance is felt.
4. Verify lift point, then center jack saddle under lift point.
Pump handle to contact lift point. To lift, pump handle
until load reaches desired height.
5. Transfer load
immediately
to a pair of jack stands:
a.
Carefully
position the stands so that load is
centered on the saddle. Ensure that ratchet is
secured before loading.
b.
Slowly
lower the vehicle onto stands. Ensure the
vehicle is secured before working on, around or
under.
NEVER
use hydraulic jack as a stand alone
device!
ALWAYS
transfer the lifted load
IMMEDIATELY
to a pair of appropriately rated jack
stands.
Lowering
Be sure all tools and personnel are clear before
lowering load.
Slowly open the release valve!
The more you turn the handle counter-clockwise, the
faster the load will come down.
Maintain control
of the
rate of speed at which the load lowers at all times!
1. Raise vehicle high enough to clear the jack stands.
2. Remove jack stands carefully.
3.
Slowly
turn the handle counter-clockwise, but no more
than 1/2 full turn. If the load fails to lower:
a. Use another jack to raise the vehicle high enough
to reinstall jack stands.
b. Remove malfunctioning jack, then the jack stands.
c. Use the functioning jack to lower the vehicle
4. After removing jack from under the vehicle, fully
lower the saddle to reduce ram exposure to rust and
contamination.
!
!
!
!
