2
SAFETY and GENERAL INFORMATION
Save these instructions.
For your safety, read, understand, and follow the information provided with and on this
product before using. The owner and operator of this product shall have an understanding of this product and safe
operating procedures before attempting to use. The owner and operator shall be aware that use and repair of this
product may require special skills and knowledge. Instructions and safety information shall be conveyed in the
operator's native language before use of this product is authorized. If any doubt exists as to the safe and proper use
of this product, remove from service immediately.
Inspect before each use.
Do not use if broken, bent, cracked or damaged parts are noted. Any jack or jack stand
that appears damaged in any way, or operates abnormally shall be removed from service immediately. If the jack or
jack stand has been or suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly
upon it), immediately discontinue use until jack has been checked by a factory authorized service center (contact
distributor or manufacturer for list of authorized service centers). It is recommended that an annual inspection be
done by qualified personnel. Labels and Operator's Manuals are available from manufacturer.
Important:
Any
jack stand
that appears to be damaged in any way, is worn or operated abnormally shall be removed
from service and destroyed immediately. No repair shall be made to a jack stand. Replace jack stands as a matched
set. No user servicable parts are available.
PRODUCT DESCRIPTION
Service Jack
is designed to lift, but not support, one end of a vehicle. Immediately after lifting, loads must be supported
by a pair of appropriately rated jack stands. This MagicLift™ Service Jack has a unique feature that provides fast,
no load lifts
to
the jacking point, at which time it lifts in approximately 0.75~2" increments.
NEVER
use hydraulic jack as stand-alone device. After lifting,
immediately
support the lifted vehicle with
a pair of appropriately rated jack stands.
Jack Stands
are designed to support rated capacity, partial vehicle loads consisting of one end of a vehicle. Use
as a matched pair to support one end of a vehicle only.
NEVER
use automotive jack stands to support
both ends
or
one side
of a vehicle!
Use only
one (1) pair
per vehicle. Rated capacity is
per pair
only!
!
!
Figure 1 - Service Jack Components
Saddle
Front Wheel
Handle
Caster
Release
Valve
Pump
Piston
Handle Sleeve
Lifting Arm
Locking Handle
Lock Pin
Locking Pawl
(stopper)
Base Frame
Saddle
Press Tab
Figure 2 - Jack Stands Components
Ratchet Bar
