4
Device Operation (cont’d)
Channel Naming
Up to a 10-character channel name can be programmed into the data logger for each channel. This ability
helps to rename a channel in a report to distinguish it from other similarly named channels.
1. In the
Connected Devices
panel, click the device desired.
2. On the
Device
tab, in the Information Group, click
Properties
. Or, right-click the device and select
Properties
in the context menu.
3. In the Channels panel, find the channel desired, then select “
Use custom name
.”
4. This will prompt a space to type in a name.
5. Select
OK
, then there will be a prompt to reset the device, select
Yes
.
Downloading Data from a Data Logger
1. Connect the logger to the interface cable.
2. Highlight the data logger in the Connected Devices list. Click
Stop
on the menu bar.
3. Once the data logger is stopped, with the logger highlighted, click
Download
. You will be prompted to
name your report.
4. Downloading will offload and save all the recorded data to the PC.
Set Password
To password protect the device so that others cannot start, stop or reset the device:
1. In the
Connected Devices
panel, click the device desired.
2. On the
Device
tab, in the Information Group, click
Properties
. Or, right-click the device and select
Properties
in the context menu.
3. On the
General
tab, click
Set Password
.
4. Enter and confirm the password in the box that appears, then select
OK
.
LED Functionality
Primary LED (Green):
Solid when communicating with computer.
Flashes every 15 seconds when logging.
Flashes every 5 seconds when in delay start.
Secondary LED (Red):
Flashes every 5 seconds when battery is low.
Flashes every 5 seconds when memory is low.
Channel LED (Blue):
Flashes every 2 seconds when reading rate is 2 seconds or faster.
Flashes same as reading rate when reading rate is slower than 2 seconds.
OM-CP-THERMOVAULTX Series
