12
The five calibration steps are:
Step 1 – Show Data
This step introduces both the
parameters
and the
current readings
, as
received from the board. The step is
passive in the sense that it only
shows
data passed by the board, but it does not make any
change
in the
board. Some
additional parameters
may be displayed in the bottom of
the “Current Board Calibration” box. Type <Ctrl>/<I> and – as shown in
the screenshot below – the additional parameters will appear, hiding the
lower original parameters (Load Cell Output, Full Load Cell(s) Capacity,
Maximum Applied Capacity and Display Resolution). In order to hide the
additional parameters and return to all the original ones, type <Ctrl>/<I>
again.
