OMEGA AIR CDi-16B, Installation And Operating Manual

Page: 12 / 12

CDi-16B - Installation and operating manual
www.omega-air.si 12
Trouble shooting
Warranty exclusion
The guarantee shall be void if:

The installation and operating manual was not followed with respect to installation,
initial commissioning and maintenance.

The unit was not operated properly and appropriately.

The unit was operated when it was clearly defective.

Non-original spare parts or replacement parts were used.

The unit was not operated within the permissible technical parameters.

Unauthorized constructional changes were made to the unit or if the unit has been
opened/disassembled by an unauthorized person.
OMEGA AIR d.o.o. Ljubljana
Cesta Dolomitskega odreda 10
SI-1000 Ljubljana, Slovenia
Tel.: +386 (0)1 200 68 00
Fax.: +386 (0)1 200 68 50
E-mail: info@omega-air.si
www.omega-air.si
Problem Possible cause Solution
LED lights on
CDi-16B don`t
light up

System initialisation is not
performed

Power cut

Voltage is not the same as
declared for CDi-16B

Presence of voltage, time for
initialisation passed by

After connection wait 2 sec for system initialisation

Check for voltage in circuit

Check the cable and power connection

Connect CDi-16B to proper voltage

Mistake must be repaired by authorised
representative
CDi-16B
discharges
condense water
few times one
after another

Condense water discharge is
partially or completely
stopped

There`s no pressure in the
system

Valve cannot be opened

There`s a lot of dirtiness on a
probe

Clean condense water discharge including
discharge pipe

Check for possible freezing and unfreeze parts

Assure compressed air pressure

Clean the valve seat

Clean a probe

Mistake must be repaired by authorised
representative
CDi-16B doesn`t
discharge
condense water

Critical condense water level
is not exceeded

Disconnected or faulty
connected probe to
electronics or faulty PCB

Check if the device is clean and no dirt is blocking
the valve.

Check if air vent is needed

Error must be repaired by authorised
representative
CDi-16B is in
alarm mode
(red LED signal)

The device was not able to
discharge all the condensate
for longer period of time

Check if the device is dimensioned correctly (max.
condensate capacity = 45 l/h)

Clean the device