6
Technical Specifications
• Heat Seal tests all seal plates before they ship.
•
Due to the advancement of this technology, it is important to maintain the non-stick cover in good condition.
It is recommended to replace the cover once every 3 months to maintain a sanitary surface.
HOT ROD HEAT UP
• First, place the desired film in cradle mounts and thread the film up through the machine according to the
diagram on the right side of the unit.
•
Plug in the power cord. There is a switch on the right side of the electrical box that you may turn on.
• Turning on the unit will allow the film cutting rod to begin to heat, it will take a few minutes to get up to
optimal cutting temperature.
• Caution: The film cutting rod will continue to heat while the wrapper is turned on, so contact by any objects
other than the film should be avoided.
PHOTOEYE ACTUATED HEATER
•
The heat cycle in the seal plate begins when a package is placed in front of the photo-eye on the seal
plate.
•
This feature ensures that the seal plate will consume energy only when there is demand by
•
Do NOT use the seal plate as a cutting surface, this will damage the heater and non-stick cover. Seal plate
damage voids the warranty.
STAINLESS STEEL BRIDGE
•
The wrapper comes with a stainless steel bridge that can be utilized as a working surface while preparing
products.
•
The stainless steel bridge is not recommended as a cutting surface.
TWO ROLL CAPACITY
• The wrapper can hold two 20” rolls of film (2). The rolls should be mounted and threaded. There is also a
threading diagram located on the right side of the unit.
OPERATOR INDICATOR LIGHT
• A dual-colored light will change from yellow, when the plate is heating, to red when the plate is at film
sealing temperature.
GFCI
•
To maintain circuit protection and integrity, a GFCI is installed in the electrical box, and may need to be
reset if wrapper gets wet or other ground faults arise. Do NOT reset the GFCI, if visible seal plate damage
is present.
