9
Installation
Operation
CABINET LOCATION GUIDELINES
INSTALL THE UNIT ON STRONG AND LEVELED SURFACES
• Unit may be noisy and/or malfunction if surface is uneven.
INSTALL THE UNIT IN AN INDOOR, WELL-VENTILATED AREA
• For best performance, please maintain clearance of 4” on the back of the unit. Brackets should be attached
on the back of the unit.
• Outdoor use may cause decreased efficiency and damage to the unit.
AVOID INSTALLATION IN A HIGH HUMIDITY AND/OR DUSTY AREA
• Humidity could cause unit to rust and decrease efficiency of the unit.
• Dust collected on condenser coil will cause unit to malfunction.
• Malfunction due to dirty condenser will void warranty.
SELECT A LOCATION AWAY FROM HEAT AND MOISTURE-GENERATING EQUIPMENT
• High ambient temperatures will cause the compressor to overwork, leading to higher energy bills and
gradual breakdown of the unit.
• With the lid open, the unit should not be used in areas over 80 degrees. The unit should not be used in
areas over 90 degrees.
• Malfunction due to high ambient temperature will void warranty.
FOR OPTIMAL PERFORMANCE, 3” OF CLEARANCE IS REQUIRED AROUND ALL LOUVERED OR
VENTED PANELS, TO ALLOW FOR PROPER AIR FLOW
• For your convenience, a set of brackets is included to prevent this unit from being pushed up against a
wall.
• Component failure due to improper installation is not covered under warranty.
TEMPERATURE CONTROLS
• Refrigerant LED - Compressor is on.
• Fan LED - Fan is on.
• Defrost LED - Defrost cycle is running.
FUNCTIONS
ADJUSTING THE TEMPERATURE
Your new refrigerator or freezer is already factory-set to run at optimum temperatures for food safety and
should require no adjustments. Refrigerators are set to cycle between a minimum temperature of 33 degrees
Fahrenheit and a maximum temperature of 40 degrees Fahrenheit. Adjusting the temperature changes the
