13
Operation
to collect with the hand, if not in small portions; the barycentre of the mass varies continuously and causes,
a continuous change in the equilibrium and effort that the operator has to maintain. If you consider that the
operator must bend the torso to remove the portions, which can increase the risk of muscle and bone pain
with increasing masses drawn and moved by hand.
14. Do not put hands between the rotation bowl and the column wall for any reason; the distance between the
two parts meet the requirements of security, but there still remains a residual risk of catching and dragging
in if someone placed their hands or even the arms in this area.
15. IMPORTANT! Before starting the machine, check the following:
a) make sure that the line voltage of the mains supply corresponds to the identification plate and in
the relevant wiring diagram. If not, do not connect the electric supply and contact your dealer or the
manufacturer.
b) verify that the direction of rotation of the spiral is anti-clockwise (viewed from above).
SWITCHING THE MACHINE ON/OFF
After connecting the machine to the power outlet place the switch 3 to position I - ON. To turn off the machine,
place the switch to position O - OFF.
KNEADING CYCLE
Figure 11, shows to the control panel.
1. Fill the ingredients in the bowl (taking into consideration the precautions described previously) and close
the cover.
IMPORTANT! Do not put excessive amounts of ingredients over maximum capacity stated by the
manufacturer into the bowl; This might cause serious damage to the machine and, in particular, to the
motor drives. The manufacturer is in no way responsible for damage caused by failure to comply with
these instructions.
2. Turn the switch to position ON - I.
3. Set the timer on the operating time in speed 1 and 2. To do this, turn the front dial to the red indicator to the
desired time.
4. Press the start button of speed 1 (Pos.1), if you want to perform an action of pre-mixing at low speed to
allow the ingredients to bind together; when the time set on timer (Pos.2) is over, the kneading tool (spiral)
will automatically switch to speed 2 and will remain there for the time set on the timer in Pos.4. After this
time the machine will stop. You can switch from speed 1 over to speed 2 immediately or at any later time by
pressing the button in (Pos.3).
PLEASE NOTE!
If the machine is equipped with grid cover do not start in speed 2 immediately, but operate the machine in
speed 1 at least for the time necessary for the flour in the bowl to bind with the water and, not less than 120
seconds; This reduces the development of airborne flour dust and the risk to people’s health.
5. If the cycle is in progress and you lift the cover, the remaining cycle time at the time of stopping will be
saved. To resume the cycle from where it left off, lower the cover and press the START button on the speed
