10
Installation
Simply be careful to handle it with very gentle movements until it stands firmly on all wheels. Place the machine
in a safe and secure place, away from any risk of impacts and damages. The mixer standing on the floor with
its wheels can be moved around by simply pushing it; the two front wheels are pivoting, whilst the two rear
wheels are fixed. The working area around the machine must be kept as clear as possible from surrounding
obstacles in order to facilitate the normal operations (i.e. cleaning); usually leave 1000mm clearance on each
side, unless the mixer is set near an escape route, in which case you must leave at least 1200mm free.
Before using the machine, secure the two front legs to the floor (do not allow it to rest only on the wheels,
because it vibrates abnormally during kneading). Look at Figure 8:
• Remove the two fixed covers located on the sides of the base (also see Pos.1 Figure 16).
• Use a hex wrench to loosen the lock nut (Pos.2) until the thread of each leg (Pos.1) is disclosed and until
the two faces show up as in the picture here below.
• The threaded portion of each leg has two faces just above the foot area; grip these faces with the hex
socket wrench (17mm) supplied with the mixer, and turn the leg shafts until there is no more stress on the
front wheels (this means the front wheels must be able to rotate freely around both the horizontal axis and
vertical axis of rotation); Finally, lock the feet by screwing and tightening the respective nuts (Pos.2); Do
this for both feet and as much as possible by the same extent so that the mixer stands perfectly flat (use a
feeler gauge to measure the gap underneath the front wheels).
If you need to move the machine (for example for cleaning), repeat the same operation in the opposite order
and let the mixer stand on the wheels
ELECTRICAL CONNECTIONS
Let electrical works be strictly performed by skilled, licensed technicians technically qualified and informed
on the relevant safety issues, regulations and standards; Please note: electric works must be followed by
the release of an official statement of compliance. On delivery of the machine and before connecting to the
mixer to your power network, ensure that the voltage, frequency and number of phases of your power line are
the same as those required by the manufacturer on the identification plate and in the wiring diagrams on the
relevant Annexes.
