7
Operation
Maintenance
6. Bring the product in the cutting position by using the fast plate shifting lever or the slow plate shifting knob.
WARNING: Leave a 0,5 to 1,0 cm space between product and blade.
7. Turn in counterclockwise direction the blade protection block. The blade guard will move away from the
blade, exposing just the part used for cutting.
DANGER: The part of the blade used for cutting is not protected.
8.
With your right hand rotate the flywheel in clockwise direction.
With such an action you will start the slicing operation.
To unload the product, do the reverse operations.
WARNING
Once you finished the cutting operation, do not forget to put back the blade protection by following the
described instructions in reverse.
BLADE SHARPENING
If the quality of the cut is not satisfying, the blade must be sharpened. The time interval between the
sharpening operations depends on the use of the slicer and on the kind of products to be cut. This operation
must be accomplished by qualified personnel. The blade must be replaced when its diameter is 10mm shorter
than the original one.
WARNING
The replacement of the blade is a dangerous operation. If the sharpening quality is not satisfying, replace both
of the grinding stones. Please contact Omcan customer service.
WARNING
Check that the blade guard covers the part of the blade used for cutting.
SHARPENING OPERATION
For a correct blade sharpening please proceed following the instructions hereafter:
1. Clean the blade, especially from fat leftovers.
2. Distance the food-holding plate from the blade.
3. Lift up the sharpener and rotate it 180°.
WARNING: Risk of injury - Once you have removed the sharpening device, a section of the blade
remains uncovered.
4. Replace carefully the sharpener, the grinding stones will position themselves on either side of the blade.
5.
With your right hand rotate the flywheel clockwise.
6. Sharpening: Press and hold the “A” button to bring the grinding stones in contact with the blade. Perform
Summary of Contents for MS-IT-0319-M
