7
Installation
INSTALLATION TO BE DONE BY LICENSED PROFESSIONALS ONLY.
UNPACKING AND PREPARING THE APPLIANCE FOR USE
•
Unpack the appliance and remove the packing material.
•
Place the appliance on a surface which is not slippery.
CONNECTION TO THE MAINS
The connection to the electric supply have to be made by a magnetothermic omnipolar switch, with distance
of 3 mm between any objects, fuses, or by a differential properly sized according to the electric norms in force.
This socket must be dedicated to the appliance. Make sure that there is a proper grounded connection.
The appliance is equipped with a 110V/60 Hz connection.
Operation
Plug the juicer into a standard wall socket. Press switch 0-1 (A) to position (1) for operation.
When the switch has been pressed, cut the fruit to be squeezed in equal halves, take one of them and place it
on the spinner, being careful not to turn it.
The juice will pass through the filter into the bowl where it runs into a drainage tube and is collected in the juice
collector cup placed beneath the tube.
Useful advice
The juicer should only be used for the time period necessary to squeeze the fruit. Therefore, do not operate
the appliance for long periods of time when it is empty. After using the appliance, it is advisable to disconnect
it from the mains by means of the main wall switch. In case of prolonged work, the gear has a thermic switch
which will temporarily turn off the gear to let it cool.
Maintenance
Before proceeding with maintenance or cleaning, make sure that the appliance is disconnected from the power
main. No particular maintenance is required. It is advisable to always clean the appliance, the reamer, the filter
and the bowl. To do so, use a damp cloth. The filter and the crown can be removed by extracting them up and
rinsed under running water. It is suggested not to wash the appliance under water jets because the item is not
protected against pressurized water sprays. Never use bleach or chlorine detergents to clean the appliance.